The manufacturing process of the medical case shell is not complicated, but it requires fine workmanship and beautiful appearance. At the same time, it also needs to ensure the integrity of medical equipment. Therefore, from color matching to the appearance of the case, it must be strictly selected. Next, Shandong rapid prototyping manufacturer will introduce the manufacturing process and quality inspection of medical device shells to you.
The manufacturing and production process of medical machinery is the formation of parts, and then the polished parts are polished and processed. After rounding, the parts are assembled, and after assembly, the overall chassis is polished. Part of the joints are polished, and then the medical shell is sprayed. After this step, all diagnosis and treatment.
The chassis shell is finished. The following is the quality inspection of the chassis finished products. Quality inspection does not mean that it is carried out in a later step. In fact, in the case of each process, quality inspection must be carried out to reduce the rate of heavy industry machinery from each stage. Strictly control the appearance design quality and internal structure quality. The appearance quality depends on these aspects:
The appearance quality should be strictly controlled. There should be no specification nonconformity. If the maintenance fails, it must be destroyed and solved. The appearance shall not be scratched. After painting, the corrosion resistance and color deviation of the chassis shall be inspected. If it is unqualified, it shall be repaired or damaged.
In addition, when the thermal maintenance of the aluminum shell motor continues to cause posture, it is necessary to find out whether the common problem is from the aluminum shell motor or the load or maintenance of the machine and equipment, and the steady-state value is too low. After eliminating the common problems, the fund can be allocated for operation. The geographical environment should always be kept dry, the motor surface should be kept clean, and the air inlet should not be prevented by dust, synthetic fibers, etc
When the service life of the bearing ends, the vibration and noise of the motor operation will expand significantly. When the radial side clearance of the bearing is checked to ensure the following values, the bearing should be replaced. The aluminum shell motor shall be lubricated with high quality during the whole operation process. wait.
The manufacturing process and quality inspection of the medical case shell, as well as relevant precautions, you can pay attention to our website http://www.jrjmockup.com Consult and understand.