Error is inevitable in the process of hand board model processing. For example, PMMA is also our common plexiglass or acrylic acid, because the material is brittle crack, and there is no glue trace, so pay special attention to in this process, once the knife is too fast, the material may break, and then it will be scrapped, so PMMA standard sample is also more expensive, What can we do to change our mistakes? How can we deal with them?
一些手板模型的一个巨大的错误无法弥补,只能报废,如透明PMMA、PC,等等,因为透明的工件不允许有胶痕,但有些工件可以弥补损失中恢复过来,工件不透明,如ABS, POM, PA,一般为塑料部件改良。治疗方法可以用治疗材料填充在一般切或错切的地方，更常用的治疗材料是502胶混合痱子粉或原子灰。取适量花椒粉，加入502胶水制成薄糊状，混合花椒粉制成502胶水。将混合均匀的物料倒入超切处，待干燥后再进行二次加工。腻子是胶黏的，需要与干燥机配合固化。
A huge mistake of some hand board models cannot be made up, so they can only be scrapped, such as Transparent PMMA, PC, etc. because transparent workpieces are not allowed to have glue marks, but some workpieces can be recovered from the loss. Workpieces are not transparent, such as ABS, POM, PA, which are generally improved by plastic parts. The most commonly used treatment material is 502 glue mixed with prickly ash or atomic ash. Take some pepper powder, add 502 glue to make a thin paste, and mix pepper powder to make 502 glue. Pour the evenly mixed material into the over cutting place, and then conduct the secondary processing after drying. The putty is sticky and needs to be solidified with the dryer.
The structural panel is mainly used to verify the structural rationality of the product. The requirements for panel size are relatively accurate, and the requirements for panel appearance are relatively low. Foreign customers are particularly strict with these requirements. If the board is divided from the functional point of view, it can be divided into appearance board and structure board. The unstructured board is also called board appearance. It only sees the appearance and does not need activities. The so-called appearance standard only requires products of similar design, or uses the same products, and does not need any effect. It cannot be used for product sales, but mainly for exhibitions, in order to do a good job in publicity.
The board can move and structure, and can see the function of the hand. The board of the structure is hollow inside, which can be used for electronic components, and can also be used as a finished product. For example, the hand of the car model and structure must have a body, wheel, door, etc. as long as it is the general appearance, it should be assembled with the distribution components, the structure is relatively complex, and the size standard of each position is very accurate, Otherwise, there may be problems with the installation.